• General
  • Interactive mode of Herwig
  • Helpful commands in the interactive mode of Herwig
  • Why is LHC.log almost empty?
  • How do I make Herwig write out events as HepMC?
  • Which HepMC status codes are used? What do they mean?
  • How can I set up a built-in Rivet analysis?
• PDF
  • Using a built-in PDF
  • Using a PDF from the LHAPDF interface
  • Set default PDF
  • Set PDF of the hard subprocess
  • Set PDF of the LHEReader
  • Set PDF of the parton shower
  • Set PDF of the underlying event and the multi-parton interactions
  • Choosing of PDFs in NLO matching
  • How do I switch off ISR in e+e- collisions?
  • How to I include saturation?
• Hard subprocess
  • Set center-of-mass energy of hard subprocess
  • The gauge boson in my Drell-Yan process has zero pT
  • Can I simulate more than one process?
  • Which cuts are being applied?
• BSM
  • How do I disable decay modes in BSM models?
• Parton shower
  • Switch off parton shower, hadronization and decay
  • Switch off underlying event
  • Define the parton shower tune
  • UE-EE-5-MRST tune from Herwig++ 2.7.1
  • How do I turn on the UA5 Underlying Event model?
  • How to I use the Non-Perutrbative Gluon emission model?
• Decays and Particle Properties
  • Introduction
  • How do I change the mass of a particle?
  • Switch off all decays
  • List decay modes of a particle
  • Switching off decays of a particle
  • Set a particle as stable
  • How do I make a group of particles stable?
  • I’ve switched some W decay modes off but the W still decays via the switched off modes